1:10 RC Road divider

This is a 1:10 road divider for RC Tracks (Tamiya etc.) inspired by typical Highway / construction site dividers used in Germany. 2 Versions: basically both the same functionality, one with long (1_10_2) and 1cm shorter (1_10_3) connector. Can be connected with angles up to 30 degrees. Can be drilled in the roof to be filled with water or else (may drain over time) for heavier weight. Length: 170mm + Connector Print in PLA (red/white or what you like) with minimum infill (5% or less) for low material costs (ca. 55g per piece / 54g for the shorter Version). Requires Supports (normal) from 46 degrees upwards for the inner Connector.