100mm-75mm VESA to 1/4"-20 Tripod Screw Mounting Plate

Most monitors will likely be too heavy, use at your own discretion. PETG or a stronger filament is a must. A remix of lukepeters's mounting plate to also support 100mm VESA configurations. Internal max nut height is 5.75mm. There is a hexagon-shaped cavity inside the mounting plate that fits a standard 1/4"-20 nut (11mm wide by 5.5mm tall). This allows you to attach a 1/4-inch tripod screw to the back of VESA plate. The plate is 2.8mm thick except in the center where it's 10.8mm thick to allow for a tripod screw to be threaded in. You'll need to pause the print to insert a nut before the hexagon cavity is covered over.