2 1/2 inches dust extraction hose to 73mm and 35mm

I was in need of two adaptors for my band saw dust extraction hose to my workshop vacuum. The saw end is a 73mm and the vacuum uses typical 35mm tubes. The saw connection was made "conical", so it has slightly different starting and ending diameters. That helps with potential dimensional challenges. On the hose side, the threads are made for tight fit, with 3 threads and a spacing of ~10mm (that's the spacing on mine), but probably will work with 12mm and of course, less than 10mm. Recommended Print Settings: Layer Height: 0.2mm Wall Loops: 2 or more Infill Amount: 50% or more Supports: Yes, for the threads Material: I used PLA+, but whatever will work