Adapter for Large CORE One HEPA & Charcoal Filter

Remix of manmac's remix of CNC Kitchen's filter unit for the Core One. Thank you for your original models! Modified the filter to fit an adapter for a 100 mm hose to install an exhaust system. Adapter should be printed standing on the small flat side / grille and with supports, pipe part pointing upwards. Model can be divided to add a grille to one side (no top and bottom layers, infill of your choice). It's designed to be used with a second, bigger exhaust fan. There are no additional sealings between adapter and filter. Check the airflow of the system by holding a piece of paper to the grille. If it's not sucked towards it, you have to increase the airflow of the exhaust fan. Test with chamber fans set to your personal maximum. The adapter just slides over the filter and will stay in place, when there's no strain on the duct. (Used an older version on my print, where I tested a snap-fit, but it wasn't needed, so I removed it again.) Please see manmac's model for instructions on the filter.