Alternative three-part box for Rocco's Vault with Pin Tumbler Lock

I split the original box into three parts. This makes it look a bit fancier and requires slightly less material. However, the main reason for this measure was that I often encounter issues when printing large solid parts—they tend to crack. The three-part version is easier and less risky to print. The three parts can be easily glued together. Printing information All STL file are correctly aligned. box back Layer height: 0.20 Infill: 100% box ring Layer height: 0.20 Infill: 10% box wall Layer height: 0.20 Infill: In the range from 0 to 6mm, I used 15% infill; above that, 0%. I am looking forward to your Makes! :-) If you like this design, feel free to check out my others here .