Alto Slide Ocarina C5-C6 (full range A4-D6)

Be sure to also check the bass slide ocarina! https://www.thingiverse.com/thing:7321321 This is a playable sliding ocarina with alto range (max. A4-D6)! Inspired by these which are around 1 octave above this one (around C6-C7): https://www.printables.com/model/985036-pendant-slide-ocarina https://www.thingiverse.com/thing:3966702 The first link (pendant slide ocarina) is recommended due to better sound and comfortable playing. The original model is this with 4 holes: https://www.thingiverse.com/thing:1184228 But this remix is based on with the added ring, both for using as pendant and also as a support for left thumb to hold. https://www.thingiverse.com/thing:1772435 Playing: Similar to ocarina, but instead slide with right index finger while holding with left hand. For left handed version, just mirror it before printing. Printing: Recommended to print straight version (straight.stl), diagonal version is not recommended as it's uncomfortable due to small size, but included in old.zip. Put supports on build plate only for upper part of slide hole which is much overhanged, or can put support everywhere but block the support for upper body part, only the slide hole must be supported, otherwise supports inside body can't be removed after print. After print, sand it a lot or otherwise chamfer it, to ensure there's no sharpness at edges for comfortable playing. Later may chamfer the 3d model itself, or it'll be better if someone does it by remixing! Included video of playing it https://youtube.com/watch?v=K0h306yY_bY