Anbernic Handheld stand (RG 476H)

Hi makers and gamers friends Hope you will enjoy this stand I made for my Anbernic RG 476H I think it could work for another console. The 476H is 17mm think and I let some space for a 4mm foam. So you have a 25mm space without this foam. you can put a thinker console inside with a thiner protection (or not at all ^^) I made the back tall enough to give a good support but also to let the 476H fan inlet free to give it a good fresh air ! With this and tiny 8bitdo controlers you can have a good travel setup for long ours in a train with your friends ! EDIT: I made a new version that allow to plug an angled USB cable for charging. I have two different cable so I made it to allow both cable to go. I think (I know, it could have some exeptions) that it will fit with most of angled cables you can have. For this one I also add a soft feet system to print in TPU. you have to print one long foot and two round feet. If you want to make your own logo for your console, make it on a 15mm x 80mm x 0.4mm base with 7.5mm round corners. Enjoy !