Anti-rattle glass holder for X3D-v2 AMS Riser

I found the original holder from X3D allowed for the glass to slide from side to side and rattled during prints. With the Bambu Lab X1s and P1s violent movements, the glass can potentially fall off the original holder Therefore, I did the following Lengthened the support Cut a groove into the support for the glass to sit snugly I am sure printing 4 x of the side units should be enough, but I over killed it and made some back support as well *Correction - The original designer made the V3 narrower than V2 - these holders are for those who already printed V2