Avocado seed floater - mason jar compatible

Hey! I was using this model made by Mikolas Zuza , but it sadly did not fit any of my jars - it was just a little too big. Instead of scaling it down I used it as a designing excercise to make essentially the same model, except that it is smaller, and is designed for 0.6mm nozzles. How to make the model “watertight” - force the slicer to use bigger line width (eg. stock is 0.62 → use 0.67) - use higher flow ratio (eg. stock is 0.98-1.0 → use 1.1) - bump the temp up , for PLA I used 240°, instead of 205-215° which I normally use - slow the print down , I used 50-75mm/s - experiment with filaments , petg should be easier than pla for this, but I used PLA and made it work