Bambu Lab P1P Cable Chain Remix

This remix has thickened the walls of the PTFE clip as well as the walls of the Cable chain hotend mount. The original parts would easily break.. This remix is also updated to use M3 and M2.5 Threaded Inserts. No nuts or washers required. The PTFE tube hole has been cleaned up as well. Updated hardware requirements: Qty 7 : M3 hex socket or button head screws 6mm length Qty 2: M2.5 hex socket or button head screws 6mm length (optional?) Qty 7 M3 Threaded Inserts 4.6mm OD by 3mm or 4mm length Qty 2 M2.5 Threaded Inserts 3.6mm OD by 3mm or 4mm length (optional?) Follow original instructions with the following exceptions. The Cable Chain Hotend Mount is in the correct print orientation for the strongest print. Use Snug tree supports. The other parts do not need support. Install the threaded inserts before assembly. I believe the M2.5 screws and threaded are optional, as the parts are held in place with the two M3 screws through the P1P frame.