Bambu Labs P1P "Vision" cable chain mount remix

The ptfe-guide normally calls for two heat inserts. I used 3 additional short (3-4mm long) heat inserts for this remix. Insert them from the back of the part - the side that is against the case. Because of the cramped space, I also created a printed washer to help distribute the screw force. I used button capped screws to lesson potential rubbing on the wire. I printed both pieces in ASA because they will be inside the enclosure. I recommend ASA or ABS. I am not a fan of cable chains. Added weight, forced smaller bends to cabling… but with a top on the P1P and the hot end moving around so violently I assumed it was just a matter of time until the wire or ptfe tube caught on something. I bought the cable chain, or it came with something as a kit. I have a couple from different places, and they all looked the same. That said, if you have cable chain sag, you're doing something wrong. Yep, I just wrote that.