Battery Holder (AA/AAA) - Squirrely Remix

I needed a simple AA and AAA battery dispenser, and originally found ArchTyriel's remix of therocketdoc's holder, buuuuuut… My printer is all haywire and the overhangs on the ramp in the remix wouldn't print properly because my machine was sucking wind. So, this is just The Rocket Doc's model with the used battery bin sheared off. I've used way too much infill in mine, but, again, I just need something that functions and I'm done with screwing around with the printer today. Oddly, the printer had trouble with the small overhangs required to make the ramp, and you can see in the photos, the ramp is kinda ugly, but the top layer of the dispensed battery opening seemed to print through the air without support and without trouble.. Your mileage may vary. Used Creality PLA, Extruder: 220; Bed 60; spd 300mm/s; no supports; sparse infill 15%, (you can fine tune this for your own printer though; this isn't a structural part so whatever your machine can print accurately, do that) :)