Beer Create Hanger for Wall Control System

Wanted to hang my crates on my Wall Control System board. I attach the hanger using a screw and nut so that it is adjustable to the left and right. This helps when trying to put some of these right next to each other so they fit as close or far apart as you want without taking up too much space on your wall. Hardware: I used M4x12mm screws and matching nuts Printing tips: Note that the image shows a piece that connects 2 holders together but instead you can just print a left and right side and put two next to each other and it take up the same amount on space. The locking part is now under each crate holder instead of between 2 of them. You might want to print the crate hanger part with 100% infill. I had one fail with heavy enough weight in 2 crates stacked on one hanger.