BentoBox v2.0 Fan Duct w/Switch & XH2P Shroud

Models include only a modified fan duct part and a JST XH2.54 connector shroud for the BentoBox v2.0 Carbon Filter . Fan duct is modified to install a 28mm x 10mm rocker switch. The included connector shroud was modeled for a flat RJ11 wire soldered to a straight XH2P connector, which should then be hot-glued through the inspection hole after insertion for strain relief. The shroud should also work fine with loose wires if preferred. Fans are wired into the switch inside the fan duct, then a single pair is passed through the unused left rear hole into the bottom section. The shroud slides into the open notch on the left face of the original V2 part, allowing for disconnection as needed for servicing. With its low profile, this shroud, disconnect, and flat RJ11 wiring leave clearance for normal mounting on the X1C base plate.