Blades of Chaos for Lucky 13

General This gives Lucky 13 the power of the God of War. Since there is a chain attached at the end of the blades, you assemble the pieces a little bit on Lucky 13's hands. It's simple enough to slide the blade on the top of the hand, and the hilt on the excess portion sticking out on the bottom of Lucky 13's hands. Printing - General I printed everything on PLA but other material should work fine. I used a 0.2mm layer height (feel free to use the Lucky 13 recommended 0.15mm for more accuracy) on a 0.4mm nozzle. If you trust your printer, you can print the pieces in one go, I printed all the blade halves and the hilts in one print just fine. Then I printed 15 of the Chain pieces. Printing - Blades Print Method 1 - Print in halves, glue halves together (recommended) These prints in multiple segments to try and preserve some details on the blades and not require support. You will need to print each half of the blade separately and just super glue them together. You will need to print each piece listed here twice. Blade Half 1 Blade Half 2 Print Method 2 - Print blades in full, use support These prints in one piece but you should probably provide it some support. You will need to print each piece listed here twice. Full Blade Printing - Hilt The hilt will print in one piece but I recommend printing it with tree supports and they should break off really easily. You can try printing it without support depending on how good your printer tolerances are but even then, it should come out better if you use supports. You will need to print each piece listed here twice. Hilt Printing - Chain This is up to your discretion, you can print one or two and make it broken chains on the bottom of the Blades of Chaos or print a few to connect them together. You will need to print each piece listed here as to your heart's content . Chain