BLE CaberQU USB Cable Tester - alternative case

There is this fantastic USB cable testing device from CaberQU that can be found here: https://caberqu.com/ -> BLE caberQU This is an alternative case version to print yourself. You can buy the PCB and screen spare part and pack it into this case. You will need: BLE CaberQU PCB and Screen 4x Countersunk M2.5x16mm (inc. head) 1x Countersunk M2.5x5mm (inc. head) Acryl sheet, 50.5x36.0x1mm Get PCB and LCD here (under spare parts) https://caberqu.com/ Look for BLE CaberQU Screws and Acryl can be bought here: Hex Head https://s.click.aliexpress.com/e/_c2JUyEmr https://s.click.aliexpress.com/e/_c4KKLkVH Torx Head https://s.click.aliexpress.com/e/_c4KKLkVH Acryl Sheet: https://s.click.aliexpress.com/e/_c42Y3Wgb https://s.click.aliexpress.com/e/_c4LOSUwr (very simple to size: make 1 deep cut with cutter, aling on edge, fixate the top, break. Note: The markings on the cover are painted on in the slicer and not part of the STL. If you do not paint them yourself, the print will be blank. Note: The standard wall (1.5mm) might be too tight for the PCB. In this case please use the thin wall STL with 1.35mm. 1.35mm: 02 CaberQU Base v2.STL 1.5mm: 00 CABERQU - 02 CaberQU Base v2-2.STL Instruction: (see pictures) Open the LCD connector latch on the PCB, remove LCD - yes, latch, do not just pull it out! -Insert PCB into case - depending on your printer it should fit very tight. Check orientation! -Insert buttons into Block -Insert Acryl sheet -Insert LCD screen -Insert LCD lock plate -Screew on Button Block (carefull, they might fall out...) -Put a sticker on the outside to hold the buttons Now you are ready to merge the two parts. Put the base on the table -Connect LCD -Close it -Power it up to veryfy if LCD works -Insert screws, do not tighten -Rotate it so the side with the power connector faces UP and the screen towards you -Open it slightly, SHIFT panel to the right, insert spacers -Now fold it open to insert spacers on the right -Tighten Screws -Remove Tape Done - happy testing!