BTT TFT35 E3 [ender v-slot] side mount

Ender [3/v2/neo] side mount for the TFT35 display from BTT The idea here is to provide both a simple side mount using the Ender v-slot for the TFT35, and a back cover. Since I couldn't find these requirements in a single simple concept, I remix these two models to fit my need : https://www.thingiverse.com/thing:5278891/files https://www.printables.com/model/248530-bigtreetech-tft35-e3-v30-mount-no-logo-step Note : if you look carefully at the v-slot holes, you can achieve 3 different angles to position the TFT. This was printed in PETG, 0.2 and 45% infill... but 20 or 25% should be sufficient. I wouldn't recommand going below 15% because it will become loose in the long run. I used 4 insets (M3 4mm) in the front panel screw holes but it's not absolutely required (recommanded, but not required)