C3PO Eyes (with 5mm LED light holes)

top grill is printed in gold, inner round part with square pattern is printed in clear which has three 5mm hols in it to hold yellow LED lights, bottom part is printed black and also has three 5mm holes for LED lights to pass through it. I would print clear part with 15% infill and print top gold grill part with grills touching build plate. The inner clear part mesh pattern prints great and this part does not need supports for the LED holes. I saw others out there and has some improved design thoughts, I built this 100% from scratch. You may need to size up the OD to make it fit in your heads eye hole but it should be very close. If you make it a fraction of a mm smaller, you may need to exact-o the LED holes a little. Make it a little larger and LED lights will still fit just fine with glue.