Candy Dispenser for Mason Jar

JoHnEyAp's base for wide mouth Mason Jars was just what I was looking for so I could print an M&M dispenser. I tuned up the thread area to remove the blanked out original threaded section and drop down the Mason Jar threads. I then took CUBE3DWORLD's trim blank and resized it for this new threaded neck. Printed in PLA Black Sparkle & Grey @ 0.2mm layer, 2 perimeters, 15% gyroid infill. The trim blank snaps over the mason jar threads and stays with the jar. Assemble the base with the original parts from sui77's design.