Case for GODIYMODULES brand Step Down Power Supply

https://www.amazon.com/dp/B0D9LXX7GF?ref=ppx_yo2ov_dt_b_fed_asin_title Needed a case for the power supply linked above, so I made one. PSU board and lid are held with M3x6 screws, "self-thread" into the plastic. (2.8mm holes) Mounting legs were sized for #6 flat-head wood screws, at whatever length you need. Mine were 1/2" long. I found during assembly that I couldn't get the mounting screw into the corner where the fan is. The heatsink fan is too close to the mounting hole in the PCB for the head of my M3 screws, YMMV. But, even with just the other three screws, its in there solid. Slice it however your printer likes it. But I sliced the lid with 0.0 top/bottom layers, and 30% grid infill (Cura), to get the ventilation pictured. The hole in the lid is right above the output voltage adjustment pot. Can fit a tiny flathead in to adjust pot without lid removal, if so needed.