charm.Fram3 - A Shaker Charm Insert for the Fram3 CMF Phone 2 Pro Cover

About This model is a set of inserts for the Fram3 cover that is compatible with the CMF Phone 2 Pro. 📷 Image redacted — claim this model to add your own media Additional Supplies 1mm Acrylic (dimensions below) Oil (Optional, Note: Can get messy) A sealer (RTV silicone is recommended, but I used petroleum jelly) Charms What charms can be used? Any charm less than 3mm in height works! Charms typically used in shaker keychains are made of acrylic, but you can 3D print your own custom charms. 1mm Acrylic Dimensions The following dimensions have 0mm clearance. Top: 31mm x 31mm Middle: 66.5mm x 88.75mm Bottom: 37mm x 12mm Required dimensions may vary due to individual printer tolerances. Printable cutting templates have been included, but are also subject to variation printer tolerances. 📷 Image redacted — claim this model to add your own media Slicing & Printing Orient model with the open side facing up. Disable supports. Add a pause after the retaining wall is printed / before the sealing layer is printed. Print until the pause Add oil & charms Apply sealer to the ledge Place acrylic sheet If oil or sealer seeps onto the acrylic, clean it off or else the sealing layer will not stick! Continue print 📷 Image redacted — claim this model to add your own media All First Party Insert Sets a.k.a “Inserts I Would Use” sand.Fram3 (Sand Timer) HERE! charm.Frame3 (Shaker Charm) rain.Frame3 (Rainmaker) 📷 Image redacted — claim this model to add your own media