Christmas present bow maker

With this template you can turn a piece of 10mm (3/8") present ribbon into a nice bow to put on your Christmas, valentine and other presents. You need: 3,25m of 10mm wide ribbon (or 10 feet and 8" of 3/8" ribbon) scissors a stapler a piece of tape Steps: Print the attached model (obviously :-) Cut 3.25m of ribbon (10 feet and 8") Thread the start of the ribbon through the 2 slots 📷 Image redacted — claim this model to add your own media Now wrap the ribbon around the number 1 tab (from left to right) 📷 Image redacted — claim this model to add your own media Continue and wrap the ribbon around number 2 📷 Image redacted — claim this model to add your own media Keep going until you reach 8 and continue to number 1 again 📷 Image redacted — claim this model to add your own media Keep going until you've almost used all of the ribbon (this is around 5 times from 1 to 8) 📷 Image redacted — claim this model to add your own media Put 2 staples in the middle of the template to fix the ribbon in place 📷 Image redacted — claim this model to add your own media Now gently remove the template from the ribbon tab by tab (it is printed thin enough to allow a some bending) 📷 Image redacted — claim this model to add your own media Separate the layers of each of the tabs of the ribbon 📷 Image redacted — claim this model to add your own media Now put a piece of wrapped around (or double sided) tape and stick the protruding end in the center to the bottom (making a small loop). 📷 Image redacted — claim this model to add your own media Cut the other end so it doesn't protrude the bow. 📷 Image redacted — claim this model to add your own media To stick the bow to the present, use another piece of wrapped around (or double sided) tape. 📷 Image redacted — claim this model to add your own media