Cinderella's Castle from Disney World

This is a model of Cinderella's Castle from Disney World. This was originally made for the FlightGear open source flight simulator a while back. If you know where to find it and you try out FlightGear it should still be there. Scaled to just under 9 inches tall. There are 3 versions in the files. One with the walk through tunnel, one with the tunnel closed up and one with a big cone on the bottom so it can used as a tree topper. Made using AC3D. Print Settings: Suggest 3-5 walls and 15-30% infill. I like to use adaptive cubic infill or 2-3 gradual steps depending on the slicer. Recommend no smaller than 50%. Printed one at 50% and one at 75% and it printed nicely at 75%. Slow it down a little in the slicer so it catches the detail. Took about 8 hours to print at 75% size at half speed. Also, printed at 100 percent. 0.28 layers 30% cubic infill with 3 gradual steps, and 3 walls and it took 14 hours to print. This was a while back so with today's faster printers results should be better.