Combo spent primer catcher and Ammo bin holder.

Reworked a design by YAMADOG shown below which was an excellent designed primer catch. Holds about 1500 to 2000 primers. I also included the link to the nipple that bolts to the bottom of the machine to connect a tubing to designed by PAOLO_VT. That design is not included in my design files but you can get from Paolo. My bench did not have a leg to fasten the catch to so made a base that screws directly to my bench next to the INLINE FABRICATION base. My dillon bullet feeder for the 45 came with 2 springs...one long and one short. I only use the short so I trimmed the long one to use as a conduit for the primers to travel down to the catch. It works better than a hose I think. Also I did not like the place where the 750 mounts the ammo catch bin. Always had trouble getting on and off because of the proximity of the ammo chute from the machine. Was even worse when I added a digital ammo counter. So the other part of this design is a riser base and ammo box holder that now is much easier to get to. Parts used: 45 cal spring from bullet loader 5mm Knurled nuts. The holes designed in are sized for 5mm 5mm cap screws I printed in PETG but could probably be just as good with PLA or PLA+ since it is not really a stress part. Print with supports ON.