Compact Aeropress stand

I was looking for compact Aeropress stand where you can put wet Aeropress and made my own at the and. It os operable with one hand https://youtu.be/MN7NjjIFZx8 and https://youtu.be/F2E1La8M5lQ It do not have place for spoon but I do not use it, if some one need it can be put in the piston. Except printed parts it require: 2 cylindrical magnets 10x4.5 (diameter 10) (one can change in .scad file) 3 M2 x 8 screws (2 for post to base, 1 for top to post) 1 M2 x 12 screw (for handle) The magnets should be put in its pocket during print (just pause print before printing pocket top). Magnets should be put correctly oriented in the pockets, the best is put magnets side by side and mark one side, then put them so marking will be on the same side if closed. If you mistaken it is better reprint lid. If one will try to use .scad file: limits of OpenSCAD should be increased (I have 102400000 elements) if base is not visible change HOLDER_F (I do it with step 5 from 70 to 120, but usually +/-5 helps first time, it is OpenSCAD glitch).