CORE One Bed Mounted Purge Bin + Prusa Brush Mount

Personally, I didn't really like the bottom mounted purge bins designs out there so decided to make one myself that moves with the bed on the core one. Additionally, I was looking at a way to mount the brass brush accessory and decided to combine them into one. The size of this model does not fit on the base size of the core one bed so there are two options: Split the part in two Expand the bed size setting and moving the build plate forward. See this post - https://forum.prusa3d.com/forum/user-mods/unlocking-a-little-more-build-volume-with-caveats/ (Ironically, you would have to remove this bin to extend the bed space ) Printing: .25mm layer height 3 perimeters 20% infill ABS/ASA, PETG Support Required (Snug) Assembly: There's a snap fit on the back end of the tabs that mount on the bed frame so you just push the bin in until it engages. Note: There's a bit of play since I did not spend time to measure that part exactly. I will probably not fix it the future but since the distance between the bottom snap fit tab and the top tab is slightly smaller than the thickness of the frame, friction keeps it from moving during printing. The brush is also friction fit into the slot for it. Below is the g-code (modify the nozzle cleaning line and test the vertical distance before printing) ; Nozzle Clean ; G0 X40 Y-16 F5000; G0 Z9.0 F5000; G0 X80 Y-18 Z12.0 F7000; G0 X40 Y-18 Z10.5 F7000; G0 X80 Y-18 Z10.5 F7000; G0 X40 Y-17 Z10.0 F7000; G0 X80 Y-17 Z10.0 F7000; G0 X40 Y-16 Z9.5 F7000; G0 X80 Y-16 Z9.5 F7000; G0 X40 Y-16 Z20.0 F7000; ; Line to replace below ; ;G29 P9 X208 Y-2.5 W32 H4