Creality K1/K1C Hinged Lid Riser using stock hardware

I wanted a riser for my K1C which would allow me to secure the corners using the M3x8 screws which already support the printer lid. I modified the Creality K1/K1C Hinged Riser corners to allow me to do this. Features No supports required No bed adhesion required (i.e., autobrim, raft) Additional parts required Four M3x8 screws which are already with the printer to support the lid My print configuration Material: PLA Infill: 15% Infill Pattern: Gyroid Supports: No Brim/ Raft: None The hole in each corner may need to be made slightly larger in post processing to allow some extra wiggle room to avoid cross-threading the screws into the holes. Enhancements to the original design No additional hardware needs to be purchased. It is already installed in the printer,