Creality K1 Max Riser Spoolholder combo

This is a combination of the Top spool holder and the Riser for the K1 Max. It is a very basic design that I made in Creality Print itself lol. I reduced the height of the riser made by Fred Boisselier for my K1 Max since I felt it didnt need to be that tall. But then I realised the Top Spool holder design by Mic Kuo would not fit on it as it was designed around the orignal. So I changed two of the sides of the lower height riser to be able to hold a spool similar to the Spool holder design, and reused Part B and Part C, modifying them a little to fit the longer length. You can remove the glass top and feed the spool directly into the direct drive extruder, or you can leave the top on and feed the bowden from the top mounted spool, both work just as well. I increased the gap between the spoolholder rods and the spoolholder so a layer of double sided tape (sticking on only one of the two) can be used between them, removing any rattling when in use. This is a large print, I printed all the parts in Creality PLA at 0.26 with 15% infill and they all turned out good enough for my use. I have now been using this for several prints over the past two days and like it enough it share. I hope this is useful for somone else too.