Creality K2 Plus Poop Chute & Waste Bin

This is a poop chute for the K2 Plus that I've designed. It attaches with the two screws on either side of the waste chute. There's also an additional retainer bracket that utilizes (2) of the rear panel screws and it supports the end of the chute. Also included is a small waste bin. If you want to design your own bin, the distance from the bottom of the chute to the top of whatever surface the printer is sitting on is 7.875"/200mm. Note: There are two versions of the chute. v2.1 has a radiused outside corner where it wraps around the corner of the printer. V2.5 is has an angled corner. This version should be slightly easier to print. Also, you may need to source some longer M3 screws for the retainer bracket. I was able to reuse (1) of the existing screws, but the lower screw wasn't quite long enough, so I had to use a different screw that I had laying around.