Custom gear handle for Stellantis, Alfa Romeo, Fiat, Peugeot, Citroen, Opel, Jeep

Hi! This project is about creating a handle/knob for Stellantis automatic gearbox shifter. Working on it was really hard, especially manual work to make it looking like factory piece. But in cars, we can not do any compromises. All must not look cheap! The key point is the clamp, using it anyone, can created its own version of handle which sits on this clamp. All printed in ABS Main block, printed was cover with real skin, printed in all 45deg X/Y/Z (sitting on plate on supports only) Sides, sides plates, bottom where printed using 0.2mm nozzle and some pervert resolution - 0.08mm! Sides were spate and polished with send paper up to 5000 and then polished with paste. same side covers, polished painted, then polished again, painted with car glossy car varnish Some parts needs to be mirrored in slicing program. Good luck if you are crazy enough to spend a week working on it.