Custom wheels and tires for rc cars (Traxxas Slash Rustler and other 1/10 cars) (Remixed)

I remixed the original up by 150%. This was some work and took several day's to get everything to fit correctly on my traxxas slash. I split the rim so you can print it without supports. Print pins and make sure they fit tight but not too tight. Apply super glue to a Q-Tip and apply to one side of the wheel to assemble. Using guide pins push pieces together. Apply a clamp for an hour or so. E6000 glue should also work requiring a longer drying time. I printed them using PETG at 20% infill. .2 first layer and .3mm for next layers. Download the original tires and upscale them by 150% (X,Y,Z) for the ones you want. The road tires need you to paint on support to the lower angled section of the tires Just use standard supports for off road tire. 95a TPU was too hard, try 90 or 85a You'll need to glue the tires to the rims. I would first try silicon, make sure the surfaces are clean. If you use silicon you should be able to remove the tire at a later date. There's a couple of sites for original, Here's a link just in case https://www.thingiverse.com/thing:3803745 This is a thing in progress, but looks good to me