Dart Zone/Adventure Force Matrixfire Talon Magazine Adapter

Replaces the Matrixfire hopper to allow it to feed from half dart magazines. Fires even faster than the full length mag conversion. Shooting demo: https://imgur.com/a/KVH4zdz It might not be the most elegant model, but it works. Since I could not move the pusher closer to the flywheels I had to move the flywheels closer to the pusher. That means that you will have to do a bit of shell cutting to fit this adapter. However, you can convert this back to use the full length magazine adapter and hopper if you wish. There are 2 covers for this, a blank one and one with a funny cat on it. Print the cover so that it is facing up, then glue the back pieces on it. I specifically designed this to work with buffdaddy's flywheel cages for the Matrixfire, here: https://www.thingiverse.com/thing:4907272 , so if you already have a modded Matrixfire you should be able to reuse that cage in this adapter. I don't know if this would work with the stock cage. I don't recommend it, since I get around 100 fps with full length darts using the stock flywheel setup on 12v. I would imagine half darts would get even less than that. I use Worker smooth wheels in my setup, wheels with a larger diameter might not work. You might need to shift the motor housing in the flywheel cage a bit if that is the case. Also included is a mounting plate for 21a switches for a full rewire. You also might be interested in Cake's other Matrixfire stuff, like the extended battery door, stock, and various muzzles. Hardware: At least 1 pen spring for the magazine release. A long M3 Screw for the magazine release. Plus the stuff needed for a rewire: Switches, wire, flywheels and motors, etc