Dewalt belt hooked drill/impact driver + SDS mounts

All credit should be directed to BurningTreeCorpse for his time in designing these first, I only tweaked for my own uses. The green mount is BTC's original design which works for the ½" impact driver (can't remember model off the top of my head - does 950nm torque) Only tweaked the heights of these mounts to suit my combi drill and impact driver that has the belt hooks installed, and also the DCH274N sds drill which to fit under the shelf and above the organisers and not to be a face injury hazard from sticking out from under the shelf too far. So far I've only used PLA so far which with 3 walls, 20% gyroid infill and 102% flow (little tight at first however it loosens up with a little bit of use) 0.6mm nozzle. Have seen plenty of abuse and hasn't broken so far =) Print with the front of the mount (where the tool slides onto it) facing upwards, to avoid using supports, if your gantry to bed level is not square then you notice it if you increase the flow by 2% which will increase the difficulty on fitting the tool onto the mount. There could maybe be some refinement to reduce material usage and time to print with these models however I tried not to stray too far from the original design as it works =)