Dirty Knobz Knight

These pads look razor‑sharp and unapologetically aggressive—perfect for riders who like their EUC setup to feel a little sketch. The rear pad comes in two pieces; the upper section is optional and fully adjustable. Printing & Scaling Support custom scaling. Adjust X, Y, and Z independently to dial in size and depth. For the recommended fit: X/Y = 91.5% Z = 100% Depth tweak: Want thinner pads? Lower the Z‑scale (same % for every part). Default depth is already optimized, but customization is part of the fun. Mirror all parts for the opposite side. Supports required for every piece. Material & Settings Print in TPU Infill: your preference For 95A TPU, Gyroid 15–20% works well Inserts can be printed separately in any color and glued in For a stronger base: print the first 3 layers in PETG, then switch to TPU—this locks the pad to the velcro far better Printer Fit If your printer can’t fit a part, scale the entire set evenly. Largest split piece (rear pad): 217 × 219 mm Full pad (unsplit): 317 × 268 mm Corner‑trimmed versions are available for smaller beds.