DJI Mic 3 Threaded Magnet Clip Holder with (almost) perfect fit

I was looking for a decent holder/mount for using my Mic 3's on my motorcycle mounts. I recently found a decent design by a user named Einstakur3D on a different platform, but it didn't appear to hold the mic firmly enough. On a closer look, I realized the magnetic clip had additional rubber rails besides the little knobs every other design seemed focused on. Those rails prevented the clip from fully closing and evenly lying down flat. As a result, only a fraction of the possible friction and holding force was possible. So I decided to use blender to create a design with this additional detail and a direct comparison shows that it requires noticably higher force to move the clamped clip and especially pull the Mic 3 out of this improved mount. The overall appearance still resembles Einstakurs design since it looked clean and nice, but all functional parts and features are based on my own measurements. Also, I added a cylindrical hole in the base to easily add a 1/4 inch heat-set insert.