Dodge charger 2011-2022 engine dust cover

These dust cover prevent the f*ing tiny tree leaves from going under there where there is sticky rustproofing. Its a problem i had, it was hard to clean and always looked bad, they sell covers on amazon/aliexpress but it cost 50$+. Don't hesitate to post a make! Remix are VERY welcome (it needs improvement). Im not putting like 5 hours to design a plastic cover, its not a Great fit (see the images). My 10$ digital caliper is broken, its been designed in an hour with a measuring tape. If you want a cover for the ugly yellowish cooling reservoir : https://www.thingiverse.com/thing:6573702 Made for my dodge charger pursuit 2017 AWD but it should fit all 2011-2022 dodge charger. If its too large for your printer you can try to put it in a 45degree angle. There is also 3 stl, its the lower piece that i sliced in 2 pieces so it can fit on 225mm printers if you use this you need to glue the lower dust cover with the Side lower dust cover with superglue or epoxy. ASA, PA, PC, ABS. It needs to survive the engine bay temperature (PETG NOT RECOMMANDED)