Dog Poop Bags Roll Dispenser with Lid - Better Printability

Original Description Holds 10 rolls of bags and has screw holes to be wall mounted, or use two sided tape/Command Strips to attach. Bag rolls are about 30mm in diameter and 61mm wide, so this dispenser might work with others. Initially designed without the odd angled surface inside, but before that was added I found that the rolls would get stuck on each other and just "hang", and not roll downwards to be dispensed. The angled surface is supported from below with another angled surface that's steep enough to not need supports. Dog bag rolls are 15 count of 9x13" bags per Amazon's description. There are sacrificial supports built into the model for the opening, so you don't have to fiddle with support settings in your slicer. Modifications I increased the wall thicknesses all over to prevent any flimsy areas and to assist with other modifications. Rounded most edges that your hand will interact with for a higher quality feel. Removed the bed facing fillet (an “infinite” overhang) as it causes printing quality issues. Replaced it with a chamfer. Made a quick simple lid to place on top for a cleaner look. Tips Make sure to set your bridge settings so it'll go all the way across the gap of the mouth in one pass. Check the images for what it should look like.