Dragon pillar (solidified)

Herostrong3d uploaded a detailed digital sculpture of a "spiral dragon pillar". However the original model's pillar is off center and the dragon relief is separated from the pillar on one side. I solidified the model which now prints as one piece. The dragon pillar is a classic Chinese architecture element. A reference picture is included. Let it decorate your desk! Print instructions Category: Buildings & Structures Print Settings Printer Brand: Prusa Printer: i3 MK2S Rafts: No Supports: Yes Resolution: 0.1mm Infill: 10% 1 gradual step Notes: Print as tall as possible and at 0.1mm layer height to show maximum detail. Support everywhere at 75-80 degrees is necessary. Make sure to use a 1mm support interface otherwise support will be impossible to remove.