Dragon Scale Pot Remix - water tight

V1 is a hollowed-out version of the original version uploaded by SassyDesign. The original is aimed at vase mode printing and I wanted a stronger and water tight version. V2 is similar to V1 but it has an added chamfer to ensure a good seal between the base and the sides. The one in the photo was upscaled and printed with a +- 20cm diameter. It was printed without support. It was printer at 0.2 layer high, 3 walls and 5% infill. I decided to up my wall count to 3 to make sure it is watertight and I then reduced the infill to bring the printing time back down. Feel free to play around with your own settings, the design is solid so you'll likely be fine with 2 walls and the standard infill setting.