Dual Spool Cord Wrap - Wider

I have a 100 ft extension cord that I needed some way to better organize. I used the original version of this , but just found that for that length, it didn't quite fit well enough, too much excess pooring out from the ends because of the length. I decided to remix the original model to make it wider, adding a support in the middle to maintain it's strength. With this, the 100 ft length fits much better. In the images I show, I actually only added 50 mm of extra width, but I am uploading a version with 60 mm of extra width. I chose to make this change because at 50 mm, the spools I am using are pushed out from center a little bit by the center support. Additionally, at 60 mm of extra width, it is the maximum size that can fit on a 250x250 mm build plate when printed on the diagonal. I did not make any changes to the original Barrel Screw, Barrel Nut, Wrench, or Cord Snaps. Please go to the original model to download the "Generic Spool 50mm ID" versions of those. You will need to print 1 extra (total 3) of the Barrel Screw and Barrel Nut.