Dummy 13 Cat Tail

A cat tail for Dummy. Make it as long as you like—10 joints plus the adapter reaches the floor without the added tip on a regularly-configured Dummy. It's a tight enough fit to hold itself upright while also being posable. Pieces snap together easily (but also pop apart easily). I used the print settings recommended for frame parts on the Dummy 13 v1.0 page. Scaled at 100%, also tested at 150%. Would highly recommend printing in PETG. Alternate stand adapter and “lion-y” tail tip optional. Note : tail tip is a hard fit (minimal flex). A twenty-second soak in hot water does the trick for me—the thin part of the socket is prone to snapping at 100% otherwise.