DUMMY 13 costume - Batman

Yet another Dummy13 Caped Crusader! My Batman has a newly designed cowl, a broad chest, abs, a cape, a utility belt, a batarang, and a holster for the batarang I used the 2x Muscled arm for dummy13 and the Hunky variant Note, all of my Dummy 13 models are printed at 150% and I doubt you'd be able to print a lot of these details at 100%. You've got to have a well-calibrated printer to print dummy 13, and these parts are no exception. Some parts will need supports, but it probably depends on your printer. Unless specified otherwise, use the parts from the original Dummy13 by Soozafone Black Frame: frame-head frame-neck (or my solid-neck ) frame-chest 2x Hunky _clavicle_2mm_added_for_hip_armor 4x frame-hip-shoulder 2x frame-upper-arm 2x frame-forearm 4x frame-knee-elbow frame-abdoment frame-hips frame-waist 2x Hunky _longer_thigh 2x Hunky _longer_shin 2x frame-ankle Armor: BatmanHead BatmanCowl – Fits tightly as-is, scale it up by 1 or 2 % to make it easy to take on and off armor-neck (unless you're using the solid-neck from above) BatmanChest armor-chest-lower 4x Dummy13 armor-hip (2 for hips, 2 for hunky shoulders) 2x armor-upper-arm or 2x “ New 2x uper arm dummy 13” 2x BatmanForearm BatmanAbs armor-crotch armor-waist 2x armor-knee 2x armor-thigh 2x armor-shin 2x armor-foot 2x armor-toe Accessories BatmanCape LegHolster Batarang Yellow Logo Belt, belt buckle, pouches, greeblies. I did 4 pouches and 2 greeblies. All of the pieces snap on to the belt, but I found that it needed superglue. Tan BatmanHead White BatmanEyes For the cape, I've done two different approaches. I printed with 45% Gyroid Infill, 1 top layer, and 1 bottom layer. Then I hit it with a heat gun to soften it and wrinkled it while it was warm. Fresh off the printer: 📷 Image redacted — claim this model to add your own media After heating and bending the left edge: 📷 Image redacted — claim this model to add your own media After shaping the whole thing: 📷 Image redacted — claim this model to add your own media Alternatively, you can use the approach laid out in multiuse flexible fabric . I used a height modifier to only enable top/bottom layers for the part of the model that clips onto the back. 📷 Image redacted — claim this model to add your own media