DUMMY 13 costume - Green Lantern (Hal Jordan)

The Emerald Knight, now in plastic! This is my Green Lantern variant of the Dummy13 figure by soozafone I used the 2x Muscled arm for dummy13 and the Hunky variant Note, all of my Dummy 13 models are printed at 150% and I doubt you'd be able to print a lot of these details at 100%. You've got to have a well-calibrated printer to print dummy 13, and these parts are no exception. Some parts will need supports, but it probably depends on your printer, and its up to you to know your printer. To assemble, press the emblem into the chest insert, and the insert into the chest. For the mask, the eyes press into the mask, the mask into the head. If any of it is too loose, use superglue. The hair has to be glued onto the head. Parts: Green Frame: frame-abdomen frame-chest 2x Hunky_clavicle_2mm_added_for_hip_armor 2x frame-ankle 2x frame-shin Armor GL_mask GL_emblem.stl GL_chest (may need supports) GL_abs 2x armor-shin 2x armor-foot 2x armor-toe 2x armor-hip (for hunky shoulders) Lantern.stl (optional) Black: Frame frame-hips 4x frame-knee-elbow 4x frame-hip-shoulder Armor armor-crotch armor-waist 2x armor-hip 2x armor-thigh Either 2x armor-upper-arm or 2x “ New 2x uper arm dummy 13” 2x armor-knee White 2x armor-forearm 2x frame-forearm GL_chest_insert GL_eyes frame hand grip left v8.stl (if you want to hold the lantern) GL_hand_ring This definitely need supports. I also added a cylinder on the build plate that was taller than the model, so that the print ends on the cylinder instead of on the ring. This one is oriented so that the ring is parallel to the bed, so that you can change the color to green at the end. I'd recommend slowing down for those layers. Brown hair Tan GL_head