Dummy 13 costume - Superman

The Man of Steel, now in plastic! This is my Superman variant of the Dummy13 figure by soozafone I used the 2x Muscled arm for dummy13 and the Hunky variant This requires a well-calibrated printer and I printed at 150%. The hair has to be superglued on to the head and the logo has to be superglued into the chest. Parts: Blue: Frame parts: 4x frame-knee-elbow 4x frame-hip-shoulder frame-abdomen frame-chest frame-hips frame-waist 2x frame-forearm 2x Hunky_clavicle_2mm_added_for_hip_armor 2x Hunky_longer_thigh 2x Hunky_longer_shin Armor parts: 4x armor-hip (2 for hips, 2 for hunky shoulders) 2x armor-knee 2x armor-thigh 2x armor-forearm armor-chest-lower Either 2x armor-upper-arm or 2x “ New 2x uper arm dummy 13” SupermanAbs SupermanChest I used supports Yellow SupermanBelt SupermanLogo - Use supports and color change to red at the correct height Red Frame: 2x frame-ankle 2x frame-shin frame-hips Armor 2x armor-shin 2x armor-foot 2x armor-toe armor-crotch armor-waist SupermanCape Tan frame-head armor-head whichever hands you want either frame-neck and armor-neck OR Solid-neck Black SupermanHair needs supports. I printed with grid supports to make it easier to remove. For the cape, I've done two different approaches. I printed with 45% Gyroid Infill, 1 top layer, and 1 bottom layer. Then I hit it with a heat gun to soften and wrinkled it while it was warm. This was the best approach. I printed in ASA, but you should be able to do the same with some trial and error in PLA. Alternatively, you can use the approach laid out in multiuse flexible fabric . I used a height modifier to only enable top/bottom layers for the part of the model that clips onto the back. 📷 Image redacted — claim this model to add your own media