DUMMY 13 goes to COMIC CON - Spider-Man

Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Get your Dummy 13 here: /model/593185 DUMMY 13 loves COMIC CON! So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON". The aim is to preserve the charm and simplicity of Dummy 13. Now to the content of Spider-DUMM , sorry Spider-Man. Mask for a white head Spider-Man hands Armor with logo Other parts are standard parts that are just printed in different colors (see pictures) Get more: More outfits /@Mici/collections/967681 More weapons /@Mici/collections/1103020 More hands /@Mici/collections/1103017 Logo: You get the best results for the logo with a 0.25 mm nozzle and 0.05 layer height . The logo is glued on and the hole in the armor helps with positioning. When gluing, make sure NOT to use any glue that attacks the material and leaves an ugly white stain. Personally, I got the model right on the first attempt. With a little skill and patience, you will also succeed. Other parts: Print the other parts with 0.15 layer height. MASK: Use brim. Slide the head into the mask and press it in with gentle force on the chin. If this is not possible, it is probably due to the following points: Check the inside of the mask (the top) to see if it has been printed cleanly and remove any filament debris that is sticking out Has the brim been removed cleanly? The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife 📷 Image redacted — claim this model to add your own media