DUMMY 13 goes to COMIC CON - The Tick

Update 08 Dec. 2023: SPOOOOON! Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Get your Dummy 13 here: /model/593185 DUMMY 13 loves COMIC CON! So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON". The aim is to preserve the charm and simplicity of Dummy 13. Have fun! Content: Mask Spoooons :D Other parts are standard parts that are just printed in different colors (see pictures) Use a white head for the eyes and some paint for the skin The antennas can be bent if you heat them carefully with a hair dryer. But don't overdo it. Get more: More outfits /@Mici/collections/967681 More weapons /@Mici/collections/1103020 More hands /@Mici/collections/1103017 Printing: Layer heightBrimSupportsMask0.15mmx-Spoons0.15mm?- Assembly: Mask: Slide the head into the mask and press it in with gentle force on the chin. If this is not possible, it is probably due to the following points: Check the inside (mostly the top and behind the eyes) to see if it has been printed cleanly and remove any filament debris that is sticking out Has the brim been removed cleanly? The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife 📷 Image redacted — claim this model to add your own media