Dummy 13 holding/waving Cowboy Hat

Dummy 13 with a cowboy hat directly merged into his hand, so it's as if he's holding or waving his cowboy hat. The STL is for his left hand, you can mirror it in the slicer to get the right hand These are the settings I used, YMMV: PLA 15% infill Organic supports on build plate only. .20mm layer height, but parts of the hat were rather thin, may be wise to use a smaller layer height Gray hat printed at 100% scale The main recommendation with supports is to avoid having support materials generate inside the socket joint, since that's both the most important part, and the hardest to sand if needed