Elegoo Centauri Carbon 2 [CC2] Magnetic Discard Bin for Supportless Chute

This is a discard bin for the Centauri Carbon 2 / CC2 that attaches magnetically, for use when there is not a surface available on the left side of the printer. It is intended for use with RndmGuy06's Supportless Chute this is posted as a remix of, and the bin is inspired by their design. It is a bit shorter in height to better align with the bottom edge of the CC2. Eight 8x3mm neodymium magnets are used. The holes are designed with clearance to make it work with a variety of filaments and print settings, so a dot of gel cyanoacrolate superglue is recommended for securing each magnet to the bin. The holes are self-supported; no supports are needed.