Elegoo Centauri Carbon 270 Degree Hinge Right side

Basically same as @MagicShrimp but opens the other way I used Elegoo Rapid PETG. I moved the Door Magnet to the Other side stuck on with Double Sided Tape. On the door I had a Metal tab off and old door Double sided tape it. Till I find something Better it works. Elegoo Tag was sliced from Elegoo Neptune 3 Series Cable Holder to cover the" Centauri Carbon" on the Door. I not a Pro just a Retired OLD FART . Required Hardware: 4x m3 8mm Socket Cap Screws (for side panel) 4x m3 12mm (or 10mm) Socket Cap Screws (for glass panel) 2x m3 30mm Socket Cap Screws (for hinges) 6x m3 Nuts 4x m3 washers thickness between .5mm and .7mm (for arms) 4x washers from existing hinge Dec.3.25 Added new lower door hinge and nut block Door Hinge tested lines up better .. Nut Block is sliced to clear the lip on the printer Sliced part is the bottom Also I used a piece of PTFE Tube as a spacer/washer for the Door (~3.5mm long may need to drill out the tube to fit the screw ) helps centering the screw thought door I don't want any Credit for this. Inspired by @MagicShrimp