Elegoo Centauri Carbon Lid and plate holder (3 and 5 plate variants). with options of with hinge, without hinge and with mounting point for wifi antenna extension.

There are a few options with this one, mainly due to requests and iterations. there is an option with and without the hinge. there is a v1 and a v2 of each as I didn't like the wobble on the plates. and there is also an option to have one with a Wi-Fi antenna holder if you decide to extend your Wi-Fi. The wifi extension helps if you are currently struggling with the printer not always loading or models taking a long time to transfer. i had this issue and moving the antenna fully fixed my issue For the non hinged version: Print the model Undo the relevant screws on the left hand side panel Install the prints with the removed screws For the hinged version: Print the model Undo the relevant screws on the left hand side panel Install the prints with the removed screws see original 270 degree hinge mod print accessories on there as well as top hinge then remove door hinges and install the hinges To extend the Wi-Fi antenna: Buy 50cm U.F.L1 to RP-SMA Buy an RP-SMA antenna Remove the screen Remove the plastic housing below the door open the bottom of the printer and remove the antenna connector on the red board (follow the antenna wire). Thread through and plug in the 50CM U.f.L1 to RP-SMA. Make small 2mm notches on the inside of the housing below the door and then one in the chamfer. Install the plastic cover ensuring the antenna wire is in these notches Thread the antenna wire through the wire guide starting at the top hinge Install the RP-SMA to the print. Install the print to the printer. Screw on the antenna Enjoy. Items to do the Wi-Fi antenna extension (affiliate) https://amzn.to/47Zg1Sx https://amzn.to/4oiQg2d Can also make a youtube tutorial if people comment wanting guidance.